AuthorOur shop blog features regular updates about the projects currently in the shop. Archives
November 2026
Categories |
Back to Blog
October 23rd, 202610/23/2026 Chris Craft SportsmanGary is working on putting the last components on the rebuilt engine in preparation for a test run. Caity brought the boat into the finish room for a final coat of varnish on the deck. Custom RunaboutJack made new, modified engine brackets and got them tested in place in the boat. Pelican electric boatPhil removed the electronics, deck hardware, and interior and washed the entire boat. After we rolled it, he started sanding and making fiberglass repairs. Flats boatJack installed the outboard engine rigging and hydraulic steering. Shane made fishing rod holders for the interior.
0 Comments
Read More
Back to Blog
Week of October 12-16, 202610/16/2026 Flats BoatWe finished mounting, installing, and wiring instruments on the helm and installed the tie down hardware for the forward casting platform. Custom CruiserWe removed the engine and the rotten floor framing and started peeling back the side planking in order to remove the transom. Chris Craft DeluxeShane finished making and dry fitting the new transom frames and battens. Concordia SloopShane reprimed the bottom after a paint failure.
Back to Blog
Week of October 5-9, 202610/9/2026 Chris Craft ContinentalWe got the engine head back from the machine shop and it's shiny and resurfaced. We also got a brand new head gasket. Concordia SloopWe permanently installed the new custom lead keel with 5200. 1982 Pelican Electric BoatWe just got in a new project this week. We're looking forward to giving this boat some TLC. Chris Craft Deluxe RunaboutShane has been removing and replicating rotten frames one by one. LarsonUnfortunately, we keep finding more delamination on the Larson as we sand back the fiberglass.
Back to Blog
Week of September 28 - October 2, 202610/2/2026 Chris Craft ContinentalJack removed the engine head and manifolds to access the valve and performed a valve adjustment. The engine head is off to the machine shop before it gets reinstalled. Custom CruiserJack removed the outboard lower unit so it can be worked on. Chris Craft DeluxeAfter discovering more rot in the transom, Shane has been removing exterior planks to access the transom frames. He's starting to replicate and replace the transom frames. LarsonPhil is doing some final sanding and prep before we make fiberglass repairs to the bottom. Chris Craft DeluxeJack bench tested the rebuilt engine, which was a success. Concordia SloopThe guys pre-drilled bolt holes on the custom cast lead ballast, painted them with a barrier coat of primer, and prefit them to the boat. We will be installing them next week.
|
RSS Feed